PVC joints are the cheapest way to build a lean pipe frame, and the quickest way to build one that fails. The distinction matters more than the price difference, because a joint failure usually takes the whole structure down with it.
Our PVC joints are moulded for 28 mm pipe with a wall thickness between 0.8 mm and 1.2 mm. They grip by interference fit and a locking screw. That is adequate for light shelving, flow rack guides, cart frames and any assembly where the load path runs down through the pipe. It is not adequate where a single joint carries a bending moment: a cantilevered arm, a hoist point, a shelf spanning more than about 900 mm without a leg under it.
Two practical notes from the factory floor. First, PVC joints should be tightened after the frame is squared, not during assembly, or the frame locks in a twist. Second, keep one spare of each type on the line: a cracked joint is a ten-second fix if you have it and a stopped line if you do not.
If you are unsure which joints a layout needs, send us the drawing. We will mark the joints that should be metal and quote both versions so the difference is visible.